SNMP Configuration Tab
[ Contents ] [ Avaya website ]

Use the Simple Network Management Protocol (SNMP) tab to set passwords, specify IP Access entries, and set Trap Host IP Addresses.

You should select new passwords during initial configuration.

  • Read Password, Confirm. Enter the SNMP password in both the Read Password field and the Confirm field. The default password is "public".
  • Read/Write Password, Confirm. Enter the password in both the Read Password field and the Confirm field. The default password is "public".
  • Configuration Trap Status. Select Enable or Disable to control this trap group.
  • Security Trap Status. Select Enable or Disable to control this trap group.
  • Wireless Trap Interface Status. Select Enable or Disable to control this trap group.
  • Operational Trap Interface Status. Select Enable or Disable to control this trap group.
  • Flash Memory Trap Status. Select Enable or Disable to control this trap group.
  • TFTP Trap Status. Select Enable or Disable to control this trap group.
  • Image Trap Status. Select Enable or Disable to control this trap group.

IP Access Table

Entries in this table show which stations are allowed to use SNMP, HTTP, and Telnet management interfaces. To add an entry, click Add, and then specify the IP Address and Subnet Mask of the station you want.

  • IP Address. Enter the IP Address for the device.
  • Subnet Mask. Enter the Subnet Mask. The Subnet Mask acts as a filter to limit access to a range of IP Addresses.
  • Interface. Specify the Interface value from the pull down menu.
  • Comment. Enter related information.

To edit or delete an entry, click Edit. Edit the information, or select Enable, Disable, or Delete from the Status pull-down menu.

Trap Host Table

To add an entry and enable the AP-3 to send SNMP trap messages to a Trap Host, click Add, and then specify the IP Address and Password for the Trap Host.

  • IP Address. Enter the Trap Host IP Address.
  • Password, Confirm. Enter the password in the Password field and the Confirm field.
  • Comment. Enter related information.

To edit or delete an entry, click Edit. Edit the information, or select Enable, Disable, or Delete from the Status pull-down menu.