Advanced Interface Configuration Settings

For Basic Interface Configuration Settings consult Basic Configuration Tabs.

Wireless Slot A and B Tabs

Wireless Distribution System setup

The Wireless Distribution System allows you to set up a wireless backbone between AP-3 devices. To setup a wireless backbone follow the steps below for each AP-3 that you wish to include in the wireless distribution system:

1. Write down the PC Card slot number (A or B) of the AP-3 device that you wish to setup for the wireless backbone link.
2. Write down the MAC Address of the Avaya Wireless PC Card inside that slot (this value is printed on a label on the back of the PC Card.
3. In the HTTP Configuration window, select the Wireless Slot tab that matches the slot value you registered in Step 1 above.
4. Enter the MAC Address that you registered in Step 2 in the Partner MAC Address field of the Wireless Distribution Setup window.
5. Set the Status for each device to enabled or disabled.

To edit or delete an entry, click Edit. Edit the information, or select Enable or Disable from the Status pull-down menu.

Ethernet Tab

Use the Ethernet category to set Ethernet speed and transmission mode.

• MAC Address. A read-only field showing the AP-3 MAC Address.
• Configuration. Select the desired speed and transmission mode from the pull down menu. The recommended setting is auto-speed-auto-duplex.